My Beauty Rest is an Amazon affiliate advertizing participant and earns commissions from qualifying purchases.

Scientists spy on Mount Etna with fiber-optic cables

Buried fiber-optic cables at Etna's summit pick up subtle volcanic activity, potentially improving early warning systems.
Enlarge / Buried fiber-optic cables at Etna’s summit pick up subtle volcanic activity, potentially improving early warning systems.

Towering 11,000 feet above a million humans, Mount Etna is one of the most thoroughly monitored volcanoes on Earth. Hundreds of sensors dot its flanks, and for good reason: it’s Europe’s most active volcano, periodically spewing lava and huge plumes of debris that ground planes and generally make life miserable for those living in its shadow.

But now scientists have been spying on Etna with an unlikely new surveillance device: fiber-optic cables, like the ones that bring you the Internet. Writing last week in the journal Nature Communications, researchers described how they used a technique known as distributed acoustic sensing, or DAS, to pick up seismic signals that conventional sensors missed. This could help improve the early warning system that people in the surrounding parts of Italy rely on. Millions more around the world are also at the mercy of active volcanoes, which create chaos whether they are large or small.

DAS is shaking up (sorry) science in a big way. When the Internet was growing in the 1990s, telecoms ended up laying down more fiber-optic cable than they needed, since the material itself was cheap compared to the labor required to bury it. That extra cable remains unused, or “dark,” and scientists can rent it out to run DAS experiments. Engineers use it to monitor land deformation, geophysicists use it to study earthquakes, and biologists are even using underwater cables to pick up the vibrations of whale calls.

Digging a trench to bury the DAC cable.
Enlarge / Digging a trench to bury the DAC cable.

Fiber optics work by transporting signals from point A to point B as pulses of light. But if the cable is disturbed by, say, an earthquake, a tiny amount of that light gets bounced back to the source. To measure this, scientists use an “interrogator,” which fires a laser through the fibers and analyzes what comes back. Because researchers know the speed of light, they can determine disturbances at various lengths along the cable: something happening 60 feet away will bounce back light that takes slightly longer to get to the interrogator than something happening at 50 feet.

These measurements are sensitive. For example, in the spring of 2020, during the early days of COVID-19 lockdowns, scientists at Pennsylvania State University used their campus’ buried dark fiber optics to observe as pedestrian and vehicle movement waned and picked up again. They could even tell the source of the aboveground disturbance by the frequency of its vibration: a human footstep is between 1 and 5 hertz, whereas car traffic is 40 to 50 hertz.

This new research centers on the same idea, only these scientists did it on an active volcano. Because telecoms never bothered to lay fiber optics on Mount Etna, the researchers dug a three-quarter-mile-long ditch less than a foot deep and buried their own, not far from the volcano’s rim.

In the image above, you can see how the fiber-optic cable was situated, its two branches outlined in white and black. (The red and yellow lines are faults.) The dots running along the cable lines are spots where the scientists had conventional sensors, like seismometers, which use pendulums to detect movement, and geophones, which convert ground movement into electrical signals. Because these sensors and the cable were colocated at those spots—at C666, C667, and so on—the researchers could compare how the different techniques were monitoring activity.

The image above shows what a volcanic explosion (not a full-on eruption) in September 2018 looked like to the DAS network. The sensing stations are noted at the top of the graphic. The red and blue represent the deformation, or “strain rate” at which the cable elongates or contracts, at a given time for every six feet along the length of the cable. “So if the cable itself is, let’s say, extended or compressed, then we see that in the signals,” says Charlotte Krawczyk, a geoscientist at German Research Centre for Geosciences and Technical University Berlin, co-author of the paper describing the work. “With all other seismic equipment, we don’t do that. We measure the acceleration of the surface or things like that.”

Notice the darker vertical red and blue band at C671, which is an increase in the signal’s amplitude. If you look back at the map, you’ll see that C671 is sitting right on a fault. “This is probably an area where the density and the velocity of the ground is different,” says geoscientist Philippe Jousset of the German Research Centre for Geosciences, lead author of the paper. That changes how the energy ripples through the earth and subsequently how the DAS reads the event.

Source link

We will be happy to hear your thoughts

Leave a reply

My Beauty Rest
Enable registration in settings - general
Compare items
  • Total (0)
Shopping cart